5-4-3 rule
Ethernet and IEEE 802.3 implement a rule, known as the 5-4-3 rule, for the number of repeaters and segments on shared access Ethernet backbones in a tree topology. The 5-4-3 rule divides the network into two types of physical segments: populated (user) segments, and unpopulated (link) segments. User segments have users’ systems connected to them. Link segments are used to connect the network’s repeaters together. The rule mandates that between any two nodes on the network, there can only be a maximum of five segments, connected through four repeaters, or concentrators, and only three of the five segments may contain user connections.
The Ethernet protocol requires that a signal sent out over the LAN reach every part of the network within a specified length of time. The 5-4-3 rule ensures this. Each repeater that a signal goes through adds a small amount of time to the process, so the rule is designed to minimize transmission times of the signals.
The 5-4-3 rule — which was created when Ethernet, 10Base5, and 10Base2 were the only types of Ethernet network available — only applies to shared-access Ethernet backbones. A switched Ethernet network should be exempt from the 5-4-3 rule because each switch has a buffer to temporarily store data and all nodes can access a switched Ethernet LAN simultaneously.
Read Also:
- 625/50
The term 625/50 refers to PAL/SECAM, the analog TV system used in Europe and other countries. It’s system of 625 scanning lines (presented as 265 scan lines (a field), interlaced, displaying 580 total lines of visible picture (a frame), at 50 hertz. This 50 hertz scanning rate results in a full frame every 1/25 of […]
- 64-bit
64-bit refers to the number of bits (the smallest unit of information on a machine) that can be processed or transmitted in parallel, or the number of bits used for single element in a data format. When the term is used in conjunction with a microprocessor, it indicates the width of the registers #&151; a […]
- 6.1 Surround Sound
A multichannel sound technology that produces 6 channels of sound in the left, right, center, left surround, right surround, and rear center positions. 6.1 systems also have 1 channel for LFE (low frequency effects) which is usually sent to a subwoofer.
- 720p
The term 720p refers to 720 lines of progressive video (720 lines per frame). Higher resolution than standard DVD, which is 480i or 480p. Usually refers to 1280×720 resolution in 1.78 aspect ratio. [Source: LG Guide to HDTV]
- 7.1 Surround Sound
A multichannel sound technology that features 7 channels of sound in the left, right, center, left surround, right surround, left rear, right rear positions. 7.1 systems also have 1 channel for LFE (low frequency effects) which is usually sent to a subwoofer.